|
|
HOME > Drop-in Network modules |
|
|
| |
|
|
 |
|
Feature |
- Plug-in
Network Module having W5100
- Useful for Designing Network Interface Part
-
Support Easy & Quick Hardware Design
- Usable without H/W design for
W5100, transformer and RJ-45
- Fast evaluation available for W5100 and MCU in the
target board
- Supports MCU BUS ans SPI Interface
- Supports auto MDI/MDIX
(auto detection of crossover)
- Supports network status indicator LEDs - FDX, TX, RX,
LINK, Collision
| | Comparison
Table (WIZ810MJ vs. WIZ811MJ vs. WIZ812MJ) | | | WIZ810MJ | WIZ811MJ | WIZ812MJ | | Architecture | TCP/IP | W5100 | | PHY | Embedded in W5100 | | Mag
Jack | RDA-125BAG1A | | Interface | 10/100 Base-T
Ethernet (Auto Detection) | | Network | Protocol | TCP, UDP, IP, ARP, ICMP, IGMP, PPPoE,
MAC | | Dimension(mm) | 52 x 25 x
21
(W x H x D) | 55.5 x 25 x 23.5
(W x H x D) | 55.5 x 25 x
23.5
(W x H x D) |
Connector Type |
2mm pitch
14 x 2
header |
2.54mm pitch
10 x 2 header |
2.54mm pitch
10 x
2 header
J29 GND
->RX_LED
J210 GND
-
>TX_LED
J219 GND
->LINK_LED | | PCB Through Hole | X | Two PCB Throughhole
(ø3.00mm)
| Four PCB
Throughhole
(ø3.00mm) | | SPI Signal
Pin | Shared for
SPI
and BUS signals | Separated for
SPI signals
(SPI_EN controlled by /SCS signal)
| Separated
for
SPI signals
(SPI_EN controlled by /SCS signal) | | LINK LED | When the link is established,
LED is on and flashes
at the TX or RX | When the link is established,
LED is on,
but not flashes
at
the TX or RX | | Input Voltage | 3.3V internal operation and 5V
tolerant I/Os | | Temperature | Operation 0 ~ 70(Centigrade
Degree)
Storage -40 ~ 85(Centigrade Degree) | | Power
Consumtion | 10/100 baseT max. 185mA (3.3V) |
|
|
|
|
|
|
