|
|
HOME > Drop-in Network modules |
|
|
| |
|
|
 |
|
 Feature |
|
- Plug-in Network Module having W5100
- Useful for Designing Network Interface Part
- Support Easy & Quick Hardware Design
- Usable without H/W design for W5100, transformer and RJ-45
- Fast evaluation available for W5100 and MCU in the target board
- Supports MCU BUS and SPI Interface
- Supports auto MDI/MDIX (auto detection of crossover)
- Supports network status indicator LEDs - FDX, TX, RX, LINK, Collision
|
| Comparison Table
(WIZ810MJ vs. WIZ811MJ vs. WIZ812MJ) |
|
| |
WIZ810MJ |
WIZ811MJ |
WIZ812MJ |
| Architecture |
TCP/IP |
W5100 |
| PHY |
Embedded in W5100 |
| Mag Jack |
RDA-125BAG1A |
| Interface |
10/100 Base-T Ethernet (Auto Detection) |
| Network |
Protocol |
TCP, UDP, IP, ARP, ICMP, IGMP, PPPoE, MAC |
| Dimension(mm) |
52 x 25 x 21
(W x H x D) |
55.5 x 25 x 23.5
(W x H x D) |
55.5 x 25 x 23.5
(W x H x D) |
Connector Type |
2mm pitch
14 x 2 header |
2.54mm pitch
10 x 2 header |
2.54mm pitch
10 x 2 header
J29 GND
->RX_LED
J210 GND
->TX_LED
J219 GND
->LINK_LED |
| PCB Through Hole |
X |
Two PCB Throughhole
(ø3.00mm)
|
Four
PCB Throughhole
(ø3.00mm) |
| SPI Signal Pin |
Shared
for SPI
and BUS signals |
Separated for
SPI signals
(SPI_EN controlled by /SCS signal) |
Separated for
SPI signals
(SPI_EN controlled by /SCS signal) |
| LINK LED |
When the link is established,
LED is on and flashes at the TX or RX |
When
the link is established,
LED is on,
but not flashes
at the TX or RX |
| Input Voltage |
3.3V internal operation and 5V tolerant I/Os |
| Temperature |
Operation 0 ~ 70(Centigrade Degree)
Storage -40 ~ 85(Centigrade Degree) |
| Power Consumtion |
10/100 baseT max. 185mA (3.3V) |
|
|
|
|
|
|
